ελληνικά
Español
Română
български език
Installation Guide
Follow the recommended preparation, measuring, cutting and bonding steps for a clean, secure and professional wall panel installation.
Careful preparation creates the best result
Wall cladding panels can be installed efficiently when the existing surface is clean, dry, stable and properly prepared. Measure the installation area carefully and confirm the position of corners, openings and electrical points before applying adhesive.
Prepare the Wall
Remove dust, grease, loose material and irregularities.
Measure and Plan
Mark the panel positions and decorative direction.
Cut Accurately
Measure carefully around sockets, corners and openings.
Bond Securely
Apply suitable adhesive and press the panel evenly.
Begin with a clean, dry and stable wall
The condition of the existing wall directly affects adhesion and the final appearance of the installation.
- Remove dust, grease and loose paint
- Repair cracks, holes and damaged areas
- Correct significant surface irregularities
- Make sure the wall is completely dry
- Confirm that existing tiles are firmly attached
Prepare everything before you begin
Correct tools help maintain accurate measurements, clean cuts and consistent adhesive coverage.
Use an adhesive suitable for PVC panels and the specific wall surface. Follow the adhesive manufacturer’s application and curing instructions.
Install the panels carefully and consistently
Work from the selected starting point and check alignment before fixing each panel permanently.
Plan the Layout
Determine the first panel position and plan the pattern direction before applying adhesive.
Tip: Dry-position the first panels before bonding.Mark the Starting Line
Use a spirit level to create an accurate vertical reference line for the first panel.
Tip: Do not rely only on the existing wall corner.Measure and Cut
Transfer the measurements to the rear surface and make clean cuts with an appropriate tool.
Tip: Confirm every measurement before cutting.Apply the Adhesive
Apply the selected adhesive according to its technical instructions and recommended coverage.
Tip: Avoid excessive adhesive near panel joints.Position and Press
Place the panel against the marked line and press evenly across the entire surface.
Tip: Check alignment before the adhesive begins setting.Continue the Installation
Install each following panel while maintaining clean joints and pattern continuity.
Tip: Remove fresh adhesive residue immediately.Plan corners, joints and openings carefully
Accurate finishing around corners, sockets, doors and openings improves the appearance and long-term performance of the installation.
Allow the adhesive to cure correctly
Protect the newly installed panels until the adhesive has reached its specified curing time.
Remove Residue
Clean fresh adhesive carefully before it dries.
Protect the Surface
Avoid impact, cleaning and unnecessary moisture.
Inspect the Installation
Check edges, joints, corners and openings.
Choose the wall panels for your project
Explore the complete collection of wall cladding panels in 122 × 280 cm format and choose the design that best suits your interior.
View Wall Panels